Magnet Making How to Guide

Magnet Making How to Guide
  1. Place your magnet maker and cutter on a flat and stable hard surface.
  2. Use only 115gsm paper or thinner
  3. Print and cut out your photos using the cutter provided.
  4. In mould A place:
    1) Metal plate
    2) Printed paper
    3) Mylar sheet
    Make sure that there is only 1 of each material in the mould.
    Make sure to align the materials as below.
  5. Rotate the bottom plate and press mould A
  6. In mould B place 1x plastic backing
  7. Rotate the bottom plate and press mould B
  8. Make sure to align all materials in each mould correctly.
  9. Make sure to press each mould with a smooth, single pull down of the lever.
    Stopping half way or applying an uneven pressure may result in the magnet not pressing correctly.
  10. Make sure to always purchase the materials from your magnet maker supplier!
    This is very important as even the slightest difference in materials can cause a permanent damage to the maker!
  11. Make sure to always clean you magnet maker and cutter after each use.
  12. Make sure to oil your magnet maker and cutter regularly.
    The frequency will depend on the usage with an increased maintenance required if used in a humid environment.